If it does not work with deluge or qBittorrent, but does work with Transmission, then at least it hints that there’s something about libtorrent-rasterbar that is at fault. Since aria2c didn’t even work at all, another alternative to rule out libtorrent-rasterbar is Transmission. But for some reason, when you use aria2c it doesn’t even start downloading? Using aria2c was a means to test out torrent downloads with a client that does not use libtorrent-rasterbar. This is looking more and more like a particular issue of libtorrent-rasterbar I also tried creating a new user and downloading the same torrent with qBittorrent logged in as the new user, again the same error. I tried setting the download destination on qBittorrent to a separate SSD I use for storage and it produced the same error. I have tried downloading under a different user, to a different folder and to a different storage device entirely, it still errors I am using EXT4 on my Manjaro partition and downloading to the default downloads folder in the same partition I have done a full memory test using a bootable Memtest86 USB and it passed without errors I have done tests on my disk using gsmartcontrol and there are no errors, it says health assessment is “PASSED”. I have already downloaded these same torrents before when I used Windows and it didn’t give that error then. This error does not happen 100% of the time, in rare instances it does complete from start to end without erroring, but I would say the chance of it erroring is 80-90%. After the error I can let it resume and it will download and complete normally. Every other torrent that doesn’t match that description didn’t give this error. Reason: TORRENTNAME file_open (/home/USER/Downloads/TORRENTNAME/FOLDER/IMAGE.jpg) error: No such file or directoryĮach time with a random image in a random folder. I have been getting this error with torrents that include several folders and several images inside the folders:Īn I/O error occurred for torrent ‘TORRENTNAME’. Robocopy C:\Users\Public\Documents\qnap \\QNAPTS112NAS\backups\qnap *.txt /mir /fft /r:2 /log:C:\Users\Public\Documents\test.I downloaded qBittorrent from Pamac and have been downloading some torrents. Robocopy windows folder to QNAP TS-112P volume ok Robocopy C:\Users\Public\Documents\qnap \\QNAPTS112NAS\USBDisk1\backups\qnap *.txt /mir /fft /r:2 /log:C:\Users\Public\Documents\test.txt /teeĤ 16:40:21 ERROR 50 (0x00000032) Changing File Attributes C:\Users\Public\Documents\qnap\copy_to_USBDisk1.txt ![]() Robocopy windows folder to USBDisk1 error Restarting QNAP TS-112P fixes 'can not be seen by a Windows 7/10 pc' problem only for few hours. ![]() When this error occurs the QNAP TS-112P network is ok because the VPN and web logins functions are ok. Build 20170606 sometimes the QNAP TS-112P volume can not be seen by a Windows 7/10 pc. I also note the sometimes since updating to QTS 4. ![]() I have tried a different WD (Western Digital) My Book Essential (USB 3.0) external drive which also has problem. The previous release 4.2.4 build 20170313 works ok. See below ERROR 50 (0x00000032) Changing File Attributes. Build 20170606 firmware has a introduced a problem with WD (Western Digital) My Book Essential (USB 3.0) external drives using robocopy (from Windows 7/10 pc) to copy files from internal volume to external drives attached to QNAP TS-112P USB port.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |